Safeline STANDARD SERIES Manuel d'instructions télécharger pdf (Page 30)

Page 14

ENTERING THE ACCESS CODES

All Safeline metal detectors are shipped from

the factory with the following access codes.

Code 0001 = Operator Access

Code 0002 = Supervisor Access

Code 0003 = Engineer Access

Code 0004 = QA Inspector Access

These codes may be changed in the

Engineer’s access mode.

Please take care to memorise or

record your new access codes

To enter the access codes use the following

procedure.

1) Press PROG/EXIT

Display reads 0000 note the cursor bar

under the left digit.

2) Press UP/DOWN keys and set to required

value.

3) Press ENTER 4) Repeat steps 2) and 3)

for each digit.

For security reasons the number changes to

a after each entry.

If a digit is entered in error the RECALL key

may be used to move back to the erroneous

digit.

When entering the security code a time of

sixty seconds is allowed between each key

operation,if this time period is exceeded the

programme will automatically return to the

running mode.

Similarly having entered the security code a

period of five minutes is allowed between

key ’operation before automatically reverting

back to the running mode.

USING THE TOUCH KEYS

Cursor Move Key

This key is used to control the movement of

the cursor bar when changing the setting of a

digital value.

A small cursor bar will appear under the

active digit on the LCD display when a

parameter is available for adjustment

Example 1 2 3 4

one press of the cursor move cursor bar one

step to the left. this key and the Up/Down

adjustment of all the digits.

key will move the Combined use of keys will

enable.

Note:- This key will only operate when the

cursor bar is visible on the LCD display.

Up/down keys

Use of these keys will increase or decrease

the value of a particular digit.

Note:- This key will only operate when the

cursor bar is visible on the LCD display.

Prog/Exit

When operated in running mode will bring up

the ’ENTER SECURITY CODE’ display and

is the first step to gain access into the

programme. If operated whilst in any of the

access modes will exit the programme and

return to the running mode display.

Enter

Used to enter data into the computer

memory. For example when changing the

sensitivity on the display it is necessary to

press the ENTER key to memorise the new

vaIue.

Recall

Use this key to scroll backwards to the

previous display page on the LCD

NB:- The ETC soft key is used to scroll

forward.

Soft Keys

The function of the four soft keys is

controlled by software and will change

dependent upon where you are in the

programme.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 80 81

Commentaires sur ces manuels

Pas de commentaire